深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 1 of 13 Specification Approval Sheet 产品规格书 QR-YF-QP-030-017 Battery Type:GRP4830048-30C-11.1V 450mAh 电池型号:GRP4830048-30C-11.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 2 of 13 QR-YF-QP-030-017 Amendment Records (修正记录) Edition Description Prepared by Checked Date (版 本) (记 述) (编 制) (审 核) (日 期) A First Publish(首次编写) HeLei TanXinRong 2022-04-27 NOTICE OF PROPRIETARY PROPERTY: THE INFORMATION CONTAINED HEREIN IS THE PROPRIETARY PROPERTY OF GREPOW.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 3 of 13 QR-YF-QP-030-017 Appendix 附 Customer's Checking Criterion (customer required) 客户验收标准(客户必填): □ √ By Grepow's Testing Criterion for Lithium Polymer Battery。 按格瑞普电池有限公司电池检验标准 □ By Customer's Testing Request and Criterion(Customer must supply the checking criterion) 按客户要求检验(需附验货标准) NOTICE OF PROPRIETARY PROPERTY: THE INFORMATION CONTAINED HEREIN IS THE PROPRIETARY PROPERTY OF GREPOW.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 4 of 13 QR-YF-QP-030-017 Content 目录 1. Scope 适用范围 ------------------------------------------------------------------------------------------------- 2. Specification 产品规格 5 ----------------------------------------------------------------------------------------- 5 ------------------------------------------------------------------------------------- 6 3. Pack Drawing 组装示意图 4.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 5 of 13 QR-YF-QP-030-017 1. Scope 适用范围 This document describes the Product Specification of the Lithium-Polymer (LIP) rechargeable battery cell supplied by Grepow Battery Corporation Limited. 本规格说明书描述了深圳市格瑞普电池有限公司生产的可充电聚合物锂离子电池的产品性能指标 2. Specification 产品规格 NO. Items Specifications 1 Connecting mode(组合方式) 2 Nominal capacity(标称容量) 450mAh @ 0.2C Discharge(放电) 3 Minimum capacity(最小容量) 392mAh @ 0.
DOC NO.: 017 REV. : A Page 6 of 13 深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD QR-YF-QP-030-017 3. Pack Drawing 组装示意图 插头 2/Plug2 插头 1/Plug1 JST-XHR-4P 反向 JST-SYP-2P 公插 产品参数 Product parameters: 项目 Items 标准 Standard 厚度 Thickness(T) 14.5±2mm 宽度 Width(W) 31.5±1.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 7 of 13 QR-YF-QP-030-017 4. Performance And Test Conditions(电池性能及测试条件) 4.1 Standard test condition(标准测试条件) Unless otherwise specified, all tests stated in this Product Specification are conducted at below Condition; 除非特别说明,本标准书中所有测试均在以下环境条件进行; Before proceed the following tests, the battery should be discharged at 0.2C to 9.6V,cutoff.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 8 of 13 QR-YF-QP-030-017 4.4 Routine Inspection And Testing Of Battery Performance 电池常规性能检查及测试 NO 序号 1 2 3 4 Items 测试项目 Test Method and Condition 测试方法和条件 High Temperature:Storage 2 hrs at 60±2℃ after standard charge,0.5C discharge at 60±2℃; 高温:标准充电后储存在 60±2℃ 的环境中,2 小时后用 0.5C 放电; Discharge Performance at Room Temperature:Storage 2 hrs at 20±2℃ after standard different charge,0.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 9 of 13 QR-YF-QP-030-017 Appendix Handling Precautions and Guideline 附录 For LIP(Lithium-Ion Polymer)Rechargeable Batteries 聚合物锂离子充电电池操作指示及注意事项 Preface This document of’ Handling Precautions and Guideline for LIP Rechargeable Batteries shall be applied to the battery cells manufactured by GREPOW.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 10 of 13 QR-YF-QP-030-017 beyond 12.75V(Cell 4.25V),which is the absolute maximum voltage, must be strictly prohibited:The charger shall be designed to comply with this condition.It is very dangerous that charging with higher voltage than maximum voltage may causedamage to the cell electrical, mechanical safety performance and could lead to heat generation or leakage. 充电电压不得超过本标准书中规定的额定电压 12.6V(单颗 4.20V),12.75V(单颗 4.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 11 of 13 QR-YF-QP-030-017 The rapid charging shall be started after the (individual) cell voltage has been reached above 3.0V within 15-30 minutes that can be determined with the use of an appropriate timer for pre-charging. In case the (individual) cell voltage does not rise to 3.0V within the pre-charging time, then the charger shall have functions to stop further charging and display the cell/pack is at abnormal state.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 12 of 13 QR-YF-QP-030-017 ·应清洁工作环境,避免有尖锐物体存在; 4.3 Folding edge 折边 •The folding edge is form in battery process and passed all hermetic test •Don’t open or deform folding edge •折边在电池生产过程中已完成,并通过了密封测试。 •禁止打开或破坏折边。 4.3 Mechanical shock 机械撞击 •Don’t Fall, hit, bend battery body •禁止坠落、冲击、弯折电池。 5. Notice Designing Battery Pack 电池外壳设计注意事项 5.
深圳市格瑞普电池有限公司 SHENZHEN GREPOW BATTERY CO., LTD DOC NO.: 017 REV. : A Page 13 of 13 QR-YF-QP-030-017 Never incinerate nor dispose the cells in fire. These may cause firing of the cells, which is very dangerous and isprohibited. 在任何情况下,不得燃烧电池或将电池投入火中,否则会引起电芯燃烧,这是非常危险的,应绝对禁止。 7.4 The battery has no waterproof function, do not sprinkle liquid on the battery or put the battery into the liquid. The liquid means water, juice, coffe or other corrosive liquid and so on.