Installation Instructions

Error! Use the Home tab to apply 标题 1 to the text that you
want to appear here.
22 FA50 Operation Manual
need to change the sample type, click “Cancel”. After reselecting
the sample type, click “STD Mode” to start the test again. If the
current test item is the same as the last test item, the analyzer will
enter the standard measurement process, as shown in Fig. 5-5-5. If
the current test item is different from the last test item, the
instrument will prompt “Item information changed, please confirm
the information before starting the test”, as shown in Fig. 5-5-4.
After confirming that the item information and sample information
are correct. Click “STD Mode” again, the analyzer starts measuring,
as shown in Fig. 5-5-5. When the countdown ends, the
measurement starts automatically, as shown in Fig. 5-5-6. After the
test is completed, the result is displayed in the lower right corner of
the measurement interface. The results displayed in the display box
are shown in Fig. 5-5-7:
Fig. 5-5-4