Product Manual

Part No. 145358 Genie IWP Super Series 3
Operator’s ManualFifth Edition • Third Printing
SAFETY RULES
Electrocution Hazards
This machine, even with an optional fiberglass
platform, is not electrically insulated and will not
provide protection from contact with or proximity to
electrical current.
Keep away from the machine if it contacts
energized power lines or becomes electrically
charged. Personnel on the ground or in the
platform must not touch or operate the machine
until energized power lines are shut off.
Maintain safe distances from electrical power lines
and apparatus in accordance with applicable
governmental regulations and the following chart.
Voltage Minimum Safe
Approach Distance
Phase to Phase Feet Meters
0 to 300V Avoid Contact
300V to 50KV 10 3.05
50KV to 200KV 15 4.60
200KV to 350KV 20 6.10
350KV to 500KV 25 7.62
500KV to 750KV 35 10.67
750KV to 1000KV 45 13.72
Do not replace items critical to stability with items
of different weight or specification.
When moving the machine with a forklift or other
transport vehicle, the platform should be fully
lowered, the machine should be turned off and no
personnel shall remain in the platform.
Do not install the outreach option on an IWP-25S or
an IWP-30S. The outreach option is for the
IWP-20S.
Fall Hazards
The guard rail system provides fall protection. If
occupants of the platform are required to wear
personal fall protection equipment (PFPE) due to
job site or employer rules, PFPE equipment and its
use shall be in accordance with the PFPE
manufacturer’s instructions and applicable
governmental requirements. Attach the lanyard to
the anchor provided in the platform.
Do not sit, stand or climb
on the platform guard rails.
Maintain a firm footing on
the platform floor at all
times.
Do not exit the platform
while raised. If a power
failure occurs, have ground
personnel activate the
manual lowering valve.
Keep the platform floor clear of debris.
Lower the platform entry mid-rail before operating.