Product Manual

18 Genie IWP Super Series Part No. 145358
Operator’s Manual Fifth Edition • Third Printing
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the work place.
5 Only use the machine as it was intended.
Setup
1 Pump the foot pedal to
raise the base until the
wheels contact the
ground.
2 Use the steering handle
to push the machine.
3 Position the machine on a firm, level surface
directly below the work area.
4 Pull the base lowering
handle to lower the base
until all four footpads are
in firm contact with the
ground.
5 Connect to an appropriate power source:
DC models: Connect the battery pack.
AC models: Connect to a grounded
15A AC power supply. Use a 12 gauge /
3.3mm
2
3-wire grounded extension cord no
longer than 50 feet / 13 m.
6 Insert the key and turn to platform control.
7 Pull out the red Emergency Stop button at the
ground controls and be sure the power light is
on.
Fundamentals
The Operating Instructions section provides
instructions for each aspect of machine operation.
It is the operator's responsibility to follow all the
safety rules and instructions in the operator's,
safety and responsibilities manuals.
Using the machine for anything other than lifting
personnel, along with their tools and materials, to
an aerial work site is unsafe and dangerous.
If more than one operator is expected to use a
machine at different times in the same work shift,
each operator is expected to follow all safety rules
and instructions in the operator’s manual. That
means every new operator should perform a pre-
operation inspection, function tests and a work
place inspection before using the machine.