Product Manual

Operator's Manual Sixth Edition • Fourth Printing
Operating Instructions
54 GS-30 • GS-32 • GS-46 Part No. T107026
To determine the slope grade:
Measure the slope with a digital inclinometer OR
use the following procedure.
You will need:
x carpenter’s level
x straight piece of wood, at least 3 feet / 1 m long
x tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge of
the piece of wood and lift the end until the piece of
wood is level.
While holding the piece of wood level, measure the
vertical distance from the bottom of the piece of
wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply by
100.
Example:
Piece of wood = 144 inches (3.6 m)
Run = 144 inches (3.6 m)
Rise = 12 inches (0.3 m)
12 in ÷ 144 in = 0.083 x 100 = 8.3% grade
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3% grade
If the slope exceeds the maximum slope or side
slope rating, then the machine must be winched or
transported up or down the slope. See Transport
and Lifting section.
Operational indicator codes
If the platform controls LED or ground controls LCD
diagnostic readout displays an operational
indicator code such as LL, the fault condition must
repaired or removed before resuming machine
operation. Push in and pull out the red Emergency
Stop button to reset the system.
LED Readout
LCD Readout
Operational Indicator Codes
Code Condition
LL Off-Level
OL Platform Overloaded
CH Chassis Mode Operation
PHS Pothole Guard Stuck
Nd No Drive (option)
Ld Lifting Disabled (GS-3232 only)
For further information, please consult the
appropriate Genie Service Manual. A code and a
description of a code can also be viewed at the
ground controls LCD display.