Product Manual

Operator's Manual Sixth Edition • Fourth Printing
Inspections
36 GS-30 • GS-32 • GS-46 Part No. T107026
Continue pressing the outrigger enable and the
outrigger extend buttons until all outrigger indicator
lights turn solid green and a long beep is heard
from the platform controls alarm. The machine is
now level. At this point, the drive and steer
functions are disabled.
Note: If the outrigger lights are solid green, the
machine may not be level or the outriggers may not
be fully deployed if a long beep is not heard at the
platform controls alarm.
Note: If the outrigger enable and extend buttons
are released too soon during extension, the
outrigger indicator lights will continue to flash
green, indicating the outriggers are not contacting
the ground.
Note: If the outrigger enable and extend buttons
are released too soon after the outriggers have
contacted the ground, a long beep will not be heard
at the platform controls and the outrigger indicator
lights will be solid green. If a long beep is not heard
and the outrigger indicator lights are solid green,
this condition may indicate the outriggers are not
fully deployed or the machine is not level.
73 Press and hold the drive/steer function enable
switch on the control handle.
74 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: The machine should not move in the
directions indicated by the blue and yellow
arrows.
75 Press and hold the drive function enable switch
on the control handle.
76 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
blue and yellow triangles on the control panel.
Result: The steer wheels should not turn in the
directions indicated by the blue and yellow
triangles.
77 Press and hold the high speed lift enable
button.
78 Press the platform up button.
Result: The platform should raise to 32 ft /
9.8 m and stop.
79 Fully lower the platform.
80 Press and hold the outrigger enable button.
Result: The outriggers should not retract.
81 Press and hold the outrigger retract button.
Result: The outriggers should not retract.
82 Press and hold the outrigger enable button.
Press the outrigger retract button.
Result: The outriggers should retract. The
individual outrigger indicator lights will turn
solid green as the corresponding outrigger
retracts.
Continue pressing the outrigger enable and the
outrigger retract buttons until the outriggers are
completely retracted. Release the outrigger enable
and outrigger retract buttons when all outrigger
indicator lights turn off. All functions are now
restored.
Note: If the outrigger enable and retract buttons are
released too soon during retraction, the outrigger
indicator lights will flash green, indicating the
outriggers are not fully retracted.