Product Manual

Sixth Edition • Fourth Printing Operator's Manual
Inspections
Part No. T107026 GS-30 • GS-32 • GS-46 31
Test Emergency Lowering
15 Activate the up function by pressing the lift
enable button and platform up button, and
raise the platform approximately 2 ft. / 60 cm.
16 For GS-30 Models
Pull the emergency lowering knob located
behind the entry ladder.
For GS-32 and GS-46 Models
Pull the emergency lowering knob located on
the ground controls side of the machine, at the
steer end.
Result: The platform should lower. The descent
alarm will not sound.
17 Turn the key switch to platform control.
At the Platform Controls
Test Emergency Stop
18 Push in the platform red Emergency Stop
button to the off position.
Result: No functions should operate.
Test the Horn
19 Pull out the red Emergency Stop button to the
on position.
20 Press the horn button.
Result: The horn should sound.
Test the Drive/Steer Function Enable
Switch
21 Do not hold the drive/steer function enable
switch on the control handle.
22 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: No functions should operate.
Test the Lift Enable Buttons
23 Do not press the high speed or low speed lift
enable buttons.
24 Press the platform up or platform down button.
Result: The lift function should not operate.
25 Do not press the platform up or platform down
buttons.
26 Press the high speed or low speed lift enable
button.
Result: The lift function should not operate.