Owner's Manual

6.8
CLOSE
STOP
CAL SET
LEARN NEW XMTR?
Figure 11
Adding a Transmitter
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2) Press SCROLL (up or down) until display reads “LEARN NEW XMTR? ”
Figure 11.
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press SET/CLEAR .
Display will read “PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR.”
4) Press Transmitter button two times.
The display will read “XMTR LEARNED.” Where it assigns a random
number between 1 and 50 to the transmitter. That transmitter is
entered and ready to operate the door. (Label/mark the transmitter.)
5) Press SCROLL (up or down) to move on to another menu item,
or CAL/RUN to exit the CAL mode.
(Optional) Transmitter Programming
CAL
RUN
SCROL
SET
CLEAR
SCROLL
CAL
RUN
Removing Individual Transmitter
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2)
Press SCROLL (up or down) until display reads “REMOVE XMTR? ”
Figure 12.
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
A menu displaying the available transmitter numbers will appear.
Press SCROLL (up or down) to cycle through the menu to the
number of the transmitter to be removed. (Pressing CAL/RUN will
cancel the operation.)
The transmitter is removed.
5) Press SCROLL (up or down) to move on to another menu item,
or CAL/RUN to exit the CAL mode.
L E
CAL
RUN
C L
SCROLL
C
SE
L AR
CLOSE
STOP
CAL SET
REMOVE XMTR?
Figure 12
Removing All Transmitters
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2)
Press SCROLL (up or down) until display reads “REMOVE ALL XMTRS”
Figure 13.
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press the SET/CLEAR key.
The display will read “ARE YOU SURE.”
All transmitters are removed.
5) Press SCROLL (up or down) to move on to another menu item,
or CAL/RUN to exit the cal mode.
LO E
CAL
RUN
C L
CROLL
S
S T
E R
SET
CLEAR
4) Press the SET/CLEAR key.
SET
CLEAR
SCROLL
CAL
RUN
SET
CLEAR
SCROLL
CAL
RUN
OPEN
CLOSE
STOP
CAL SET
REMOVE ALL XMTRS?
Figure 13
SCROLL
3) Press SET/CLEAR
SET
CLEAR
4) Press SET/CLEAR
www.geniecompany.com 06-12
Standard Duty Operator
GCL-T