Owner's Manual

4.3
www.geniecompany.com 06-12
Drawbar Assembly (continued)
3) Insert the carriage into the rails as shown in Fig. 4.
NOTE: The end of the carriage with the chain tension adjustment bolt should be
toward the operator.
4) Place the spreader bracket in position around the drawbar rail. Do not
redaerps ehT .emit siht ta stun kcol dna stlob kcart eht tresni bracket
will be held in place (temporarily) by the clevis pin which holds
the pulley.
5) Install the idler pulley inside the rails by inserting the 3/8” x 4-1/2” clevis
pin through one of the rails and as you feed it through an idler
sleeve and the idler pulley followed by the second sleeve . Place fender
washer (7/16” x 1-1/4”) over end of clevis pin. Secure clevis pin using
RAIL
Figure 4
Figure 5
FRONT
SPREADER
BRACKET
WASHER
COTTER PIN
CLEVIS PIN
IDLER PULLEY
/STLOB KCART
LOCKNUTS
DO NOT INSTALL YET!
SLEEVE
NOTE: For building of the spreader bracket assembly on a Dual Trolley unit see
the separate Drawbar instruction sheet for Sidemount and Dual Trolley models.
OPERATOR
DOOR
Standard Duty Operator
GCL-T
cotter pin. Fig. 5.
CARRIAGE