Owner's Manual

Medium Duty Operator
GCL-MT
www.geniecompany.com 08-12
7.1
The operators include a built-in cycle counter that store the count with
or without power to the operator.
To view the Cycle Count:
1)
Press CAL/RUN to enter calibration mode.
2) Press SCROLL ( ) or ( ) until display reads “CYCLES
>
.”
T
his will display current cycle count.
3) Press CAL/RUN to return to run mode.
Section 7: Special Operator Features
Operator Cycle Count
Fig. 1
The operators can display the version number of the firmware used in
the on-board micro-controller.
To view this version number:
1) Press CAL/RUN to enter calibration mo
de.
2) Press SCROLL ( ) or ( ) until the display reads “FIRMWARE
>
.”
This will display the current firmware version number.
3) Press CAL/RUN to retur
n to run mode.
Circuit Board Firmware Version Fig. 2
CYCLES 1
FIRMWARE 4.00.1
Figure 1
Figure 2