Owner's Manual

Medium Duty Operator
GCL-MT
www.geniecompany.com 08-12
6.5
2) Press SCROLL (up or down) until display reads “ODC STB>ON” or
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
“ODC STB>OFF” Figure 15.
3) Press SET/CLEAR key to toggle between ON and OFF.
WARNING:
SCROLL
Figure 15
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
ODC STB ON
NOTE: Installation of Series II Monitored Photocells DOES NOT make the
unit legal for residential use.
Monitored Reversing Devices
SE
CAL
RUN
ROL
SET
CLEAR
SCROLL
CAL
RUN
LEA
Safe-T-Beams® (OPTIONAL)
4) Press SCROLL (up or down)
to shift to a new function and lock setting.
5) Press CAL/RUN to return to run mode.
Photocell systems provide entrapment
protection when mounted near the doorway in such a way
that the lower portion of an individuals leg will break the
photocell beam during normal walking through the doorway.
Current UL Approved Monitored Reversing Devices
1) MillerEdge ME and MT series monitored edge sensors used in
combination with Timer-Close Module P/N OPABTCX.S.
2) MillerEdge ME and MT series monitored edge sensors (Direct connect through STB inputs).
using OPAKMEIX.S INTERFACE MODULE.
3) Residential Safe-T-Beam® Monitored Photocells from The Genie® Company,
model OSTB-BX (P/N 38176R).
4) Monitored Photocells (P/N OPAKPEN4GX.S.).