Owner's Manual

4.8
1) Route the hand chain through the chain guide, around the
pocket wheel and back through the chain guide. Fig.10.
2) Connect the hand chain ends together as shown in Fig 11
.
by twisting open the last link on one end of the chain, and
slipping the last link on the opposite end onto the open link.
3) Twist open link closed again.
4) Mount chain keeper to wall in line with chain approximately
4 feet from floor.
5) Loop chain around keeper as shown. Fig. 12. Optional Padlock
not provided
.
6) Install release cable. Fig. 13.
NOTE: T
o insure smooth operation, make sure there are no twist in the
hand chain before connecting the link ends together.
Hand Chain & Keeper
Figure 10
Figure 11
Figure 12
Figure 13
RELEASE CORD
www.geniecompany.com 08-12
Medium Duty Operator
GCL-MJ&MH