Owner's Manual

WARNING:

SCROLL

2) Press SCROLL (up or down) until display reads “ODC STB>ON” or

6.5

OPEN

STOP

CAL

RUN

SCROLL

SET

CLEAR

ODC STB ON

NOTE: Installation of Series II Monitored Photocells DOES NOT make the operator

unit legal for residential use.

Monitored Reversing Devices

CAL

RUN

SET

CLEAR

SCROLL

CAL

RUN

ODC Safe-T-Beams® (OPTIONAL)

1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.

“ODC STB>OFF” Figure 9.

3) Press SET/CLEAR key to toggle between ON and OFF.

4) Press SCROLL (up or down)

to shift to a new function and lock setting.

5) Press CAL/RUN to return to run mode.

Photocell systems provide entrapment

protection when mounted near the doorway in such a way

that the lower portion of an individuals leg will break the

photocell beam during normal walking through the doorway.

If an alternative mounting location is chosen, it must be

approved by the facility owner.

Current UL Approved Monitored Reversing Devices (See page 5.7)

1) MillerEdge ME and MT series monitored edge sensors used in

combination with Timer-Close Module P/N OPABTCX.S or OPAKMEIX.S INTERFACE MODULE.

2) MillerEdge ME and MT series monitored edge sensors (Direct connect through STB inputs).

(Direct connect through STB inputs).

3) Residential Safe-T-Beam® Monitored Photocells from The Genie® Company,

model OSTB-BX (P/N 38176R).

4) Monitored Photocells (P/N OPAKPEN4GX.S.).

Figure 9

www.geniecompany.com 08-12

Medium Duty Operator

GCL-MJ&MH