Owner's Manual

6.1
These operators include a full function control panel including a liquid crystal
display (LCD), calibration keys and Open, Close and Stop keys for on board
operator control.See Fig.1. The open, close and stop keys function as a 3-button
wall control. The Display will show current operator conditions and calibration
information. Due to limited character space,some displays
will be abbreviated.
See Appendix C (pgs.10.7-10.9) for full display descriptions.
Operator includes a non-volatile memory. The unit will remember all
calibration settings plus error code and run code logs, if power is removed
from unit.
NOTE: During Setup, refer to Caution Label for limited use (pictured on
page 5.4).
DANGER
:
After power is supplied to the operator,
Control Operating Modes
Operator control boards operate in two modes: Run Mode and Calibration
Mode. The control board should normally operate in the Run Mode. The
operator
is calibrated in Calibration Mode.
With the operator standing idle
PRESS CAL/RUN TO TOGGLE BETWEEN OPERATING MODES.
>
***”
(*** = current operating mode).
NOTE: The CAL/RUN key will not toggle between operator modes while
the operator is running.
Section 6: Operator Setup Procedure
Control Panel
LCD DISPLAY
Figure 1
Calibration &
Run Mode
Toggle Key.
Display
Backlighting
Toggle Key.
Scroll Keys, used in
Calibration Mode.
Set/Clear Key,
used to reset
and adjust
calibration
settings.
Operation Keys,
operates unit
like a 3-button
wall station.
Do Not make contact with components inside the control panel
except for the Keypad Keys. Fig. 1.
CAL
RUN
SET
SCROLL
SCROLL
CLEAR
OPEN
STOP
CLOSE
www.geniecompany.com 08-12
Medium Duty Operator
GCL-MJ&MH