Owner's Manual

11.1
www.geniecompany.com 0-12
Standard Duty Operator
GCL-J&H
The Genie Company ("Seller") warrants to the original purchaser of this commercial door operator
(“Product”) subject to all of the terms and conditions hereof that the Product and all components
thereof will be free from defects in materials and workmanship under normal use for the following period(s) measured from the date of installation
Two (2) years or When the Operator exceeds 20 000 cycles of operation as measured by the integrated cycle counter contained in the Operator.
Seller’s obligation under this warranty is specifically limited to repairing or replacing at its option any part which is determined by Seller to be defective during the applicable warranty period. Any labor
charges are excluded and will be the responsibility of the purchaser. This warranty is made to the original purchaser of the Product only and is not transferable or assignable.
This warranty does not apply to any unauthorized alteration or repair of the Product or to any Product or component which has been damaged or deteriorated due to misuse neglect accident failure to provide necessary maintenance normal wear and tear or acts of God or any other cause beyond the reasonable control of Seller. THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER EXPRESSED OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL SELLER BE RESPONSIBLE FOR OR LIABLE TO ANYONE FOR SPECIAL
INDIRECT COLLATERAL PUNITIVE INCIDENTAL OR CONSEQUENTIAL DAMAGES even if
Seller has been advised of the possibility of such damages. Such excluded damages include but are not limited to loss of goodwill loss of profits loss of use cost of any substitute product interruption of business or other similar indirect financial loss. Claims under this warranty must be made promptly after discovery within the applicable warranty period and in writing to the Seller or to the authorized distributor or installer whose name and address appear below. The purchaser must allow Seller a reasonable opportunity to inspect any Product claimed to be defective prior to removal or any alteration of its condition. Proof of the purchase and/or installation date and identification as the original purchaser may be required.
ORIGINAL PURCHASER INSTALLATION ADDRESS SELLER: SELLER S ADDRESS:
FACTORY ORDER #:
DATE OF INSTALLATION:
SIGNATURE OF SELLER:
Commercial Operator Limited Warranty