Owner's Manual

6.8
CLOSE
STOP
CAL SET
LEARN NEW XMTR?
Adding a Transmitter
1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.
2) Press SCROLL key (up or down) until display reads “LEARN NEW XMTR? ”
Figure 13.
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press SET/CLEAR key.
Display will read “PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR.”
4) Press Transmitter button two times.
The display will read “XMTR ___LEARNED.” Where it assigns a random
number between 1 and 50 to the transmitter. That transmitter is
entered and ready to operate the door. (Label/mark the transmitter.)
5) Press SCROLL key (up or down) to move on to another menu item,
or CAL/RUN key to exit the CAL mode.
(Optional) Transmitter Programming
LO
CAL
RUN
C
SCROL
C
SE
CL AR
SET
CLEAR
SCROLL
CAL
RUN
Removing Individual Transmitter
1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.
2)
Press SCROLL key (up or down) until display reads “REMOVE XMTR? ”
Figure 14
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
A menu displaying the available transmitter numbers will appear.
Press SCROLL key (up or down) to cycle through the menu to the
number of the transmitter to be removed. (Pressing CAL/RUN will
cancel the operation.)
The transmitter is removed.
5) Press SCROLL key (up or down) to move on to another menu item,
or CAL/RUN key to exit the CAL mode.
L E
CAL
RUN
C L
SCROLL
SCROLL
CAL
RUN
CLOSE
STOP
CAL SET
REMOVE XMTR?
Figure 14
Removing All Transmitters
1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.
2) Press SCROLL key (up or down) until display reads “REMOVE ALL XMTRS”
Figure 15.
This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press the SET/CLEAR key.
The display will read “ARE YOU SURE.”
All transmitters are removed.
5) Press SCROLL key (up or down) to move on to another menu item,
or CAL/RUN key to exit the cal mode.
CAL
RUN
CROLL
S O L
SET
CLEAR
4) Press the SET/CLEAR key.
SET
CLEAR
SCROLL
CAL
RUN
CLOSE
STOP
CAL SET
REMOVE ALL XMTRS?
Figure 15
SCROLL
3) Press SET/CLEAR key.
SET
CLEAR
4) Press SET/CLEAR key.
SET
CLEA
Figure 13
www.geniecompany.com 0-12
Standard Duty Operator
GCL-J&H