Owner's Manual

The display will
Press the SET key.
SET
CLEAR
key.
6.7
www.geniecompany.com 03-12
CLOSE
STOP
CAL SET
LEARN NEW XMTR?
Figure 11
(Optional) Transmitter Programming
CAL
RUN
SCROLL
SET
CLEAR
CROL
CAL
RUN
CAL
RUN
SCROLL
SET
CLEAR
CROLL
CAL
RUN
SET
CLEAR
CLOSE
STOP
CAL SET
REMOVE XMTR?
Figure 12
CAL
RUN
SCROL
RUN
SET
CLEAR
SCROLL
S ROLL
CLOSE
STOP
CAL SET
REMOVE ALL XMTRS?
Figure 13
SCROLL
Removing All Transmitters
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2)
Press SCROLL (up or down) until display reads “REMOVE ALL XMTRS”
Figure 13.
• This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3)
• read “ARE YOU SURE.”
4) Press the SET
• All transmitters are removed.
5) Press SCROLL (up or down) to move on to another menu item,
Adding a Transmitter
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2) Press SCROLL (up or down) until display reads “LEARN NEW XMTR? ”
Figure 11.
• This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
RUN/CAL will cancel the operation.)
3) Press SET .
• Display will read “PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR.”
4) Press Transmitter button two times.
• The display will read “XMTR ___LEARNED.” Where it assigns
a random
number between 1 and 50 to the
transmitter. That transmitter is
entered and ready to operate the door. (Label/mark the transmitter.)
5) Press SCROLL (up or down) to move on to another menu item,
or CAL/RUN to exit the CAL mode.
Removing Individual Transmitter
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2)
Press SCROLL (up or down) until display reads “REMOVE XMTR? ”
Figure 12.
• This question along with the instruction “HIT SET FOR YES” will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
3) Press SET .
• A menu displaying the available transmitter numbers will appear.
Press SCROLL (up or down) to cycle through the menu to the
number of the transmitter to be removed. (Pressing CAL/RUN will
cancel the operation.)
4) Press SET .
• The transmitter is removed.
5) Press SCROLL (up or down) to move on to another menu item,
Heavy Duty Operator
GCL-GT