Owner's Manual

6.2
www.geniecompany.com 03-12
OPEN
CLOSE
STOP
CAL
RUN
SCRO
LL
SET
CLEAR
Setting Close Direction
SET CLOSE DIR
Figure 2
OPEN
CLOSE
STOP
CAL SET
HIT CLOSE KEY
OPEN
CLOSE
STOP
CAL SET
DID DOOR CLOSE?
Figure 3
Figure 4
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
Figure 5
SCROLL KEY
CAL
RUN
SET
CLEAR
CLOSE
SCROLL
SET
CLEAR
CAL
RUN
YES NO
The direction of motor rotation depends on mounting position and/or how the
main input power phases are wired. This setting is used to insure the door is
closing and opening according to the input commands.
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2) Press SET/CLEAR to begin the calibration procedure and advance to
the next screen. Figure 3.
3 ) Briefly press the CLOSE key. (Pressing the Scroll key at this point will exit
this control function.)
• The display will read “ DID DOOR CLOSE? “ Figure 4.
4) Press SCROLL key (up or down) to toggle between YES and NO.
Figure 5.
• If YES is selected, no change to operator calibration is made. If
NO is selected — the POD will change the operator’s down direction.
5) Press the SET/CLEAR key.
6) Press CAL/RUN to return to run mode.
Heavy Duty Operator
GCL-GT