Owner's Manual

6.1
www.geniecompany.com 03-12
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
Section 6: Operator Setup Procedure
These operators include a full function control panel including a liquid crystal
display (LCD), calibration keys and Open, Close and Stop keys for on board
operator control. See Fig. 1. The open, close and stop keys function as a 3-button
wall control. The Display will show current operator conditions and calibration
information. Due to limited character space, some displays will be abbreviated.
See Appendix C (pgs. 10.9-10.11) for full display descriptions.
Operators also include a non-volatile memory. The unit will remember all
calibration settings plus error code and run code logs, if power is removed from unit.
DANGER: After power is supplied to the
operator, Do Not make contact with components inside
the control panel except for the Keypad Keys. Fig. 1.
TURN ON POWER TO OPERATOR
Control Operating Modes
Operator control boards operate in two modes: Run Mode and Calibration
Mode. The control board should normally operate in the
Run Mode. The operator
is calibrated in Calibration Mode.
With the operator standing idle:
PRESS CAL/RUN TO TOGGLE BETWEEN OPERATING MODES.
• The first display in calibration mode is “set close dir.”
• The display in run mode will be one of the condition codes listed
in Appendix D.
Control Panel
Operation Keys, operate
unit like a 3-button
wall station.
Scroll Keys, used in
Calibration Mode.
Set/Clear Key, used to
reset and adjust
calibration settings.
Figure 1
Calibration & Run
Mode Toggle Key.
Display Backlighting
Toggle Key.
LCD DISPLAY
WARNING: DO NOT calibrate operator or
operate door unless doorway is in sight and free of
obstructions. Door will move during setup. Keep people
clear of opening while door is moving.
Heavy Duty Operator
GCL-GT