Owner's Manual

Low Voltage Wiring
1) Connect all LOW VOLTAGE control circuit wires to this side
of unit using 1/2” conduit or flexible convoluted tubing.
• Keep low voltage and line voltage wires separate.
• Route all low voltage control wiring as shown. Use liquid tight
fittings and conduit. This includes all control circuit wires such as
wall controls, timers and single button input devices as well as
radio control and safety circuit wiring. See Figs 2 through 10 in
this section.
• Plug all unused conduit holes with liquid tight plugs.
Low Voltage Control Wiring (general) Fig. 2
ROUTE LOW VOLTAGE WIRING
IN THE SHADED AREA AS SHOWN
LOW
VOLTAGE
INPUT
PLUGS
(Left &
Right)
LOW VOLTAGE
CONTROL WIRE
TERMINALS
Figure 2
NOTE: For a detailed description of control wire terminals see Appendix B in
the Standard GCL-GH
™
Installation Manual.
NOTE: LIQUID-TIGHT CONDUIT AND FITTINGS ARE NOT PROVIDED
(SUPPLEMENT TO SECTION 5 OF THE ACCOMPANYING GCL-GH
™
INSTALLATION MANUAL)
2
www.geniecompany.com 06-12
Heavy Duty Operator
GCL-GH