Owner's manual
(Continued)
Operating 2 or 3 Door Openers:
• To move one of the doors.
• Enter your PIN.
• Press ,
Press door opener number (C1J or or
Mount Keypad. (Mounting screws located inside
battery compartment.)
• Remove Battery Cover. See Figure 3.
• Drill a 1/16" pilot hole for the top mounting screw.
• Install a screw into the drilled hole,
leaving a 1/8" gap between the
screw head and the wall.
See Figure 2.
• Hook the Keypad over the screw.
• Mark,drill pilot hole and fasten
bottom screw.
• Reinstall Battery Cover.
A Enter your PIN
• Press
B Enter theTemporary PIN (from 3 to 8 characters).
• Press .
DO NOT reprogram the Door Opener(s).
Temporary PIN remains active until the next time your
normal PIN is entered.
Erase old PIN:
Press and hold in order
- Red LED will blink once and turn off.
• Release all buttons.
Programming Door Opener(s).
• Return to "Programming for 1 Door Opener"or
"Programming for 2 or 3 Door Openers."
24
FcM' Help, call l-SOOHJSHSEiiE or visit www.gBmstompsmi.mm