Owner's manual

A Place Magnetic Carriage Assembly Lever in "release" position.
B Slide Magnetic Carriage Assembly into slot on End Rail
Section with arrow pointing away from the Power Head
(Figure 12).
Magnetic Carriage
Assembly ^
Engaged Position
Release
Position
Toward door
and header
Toward Power Head End Rail Section
^ 0
Figure 12 Slide Magnetic Carriage onto Rail
Rail Strap
A Attach Rail Strap to End Rail Section with 2 (l/4"-20) Hex
Head Bolts and 2 (l/4"-20) Serrated Flange Hex Nuts
(Figure 13).
B Tighten snugly but Do Not over-tighten.
® © ®_
0 0
8^
\ End Rail Section
(ic)
A Align all Rail Sections so Magnetic Carriage Assembly can
slide freely along length of Rail.
B Securely tighten all fasteners now. Do Not over-tighten.
Figure 13 Attach Rail Strap
Turn Opener right side up and support Power Head to avoid
damaging the Light Bulb Sockets.
Uncoil Limit Switch Wires and retain Twist Ties.
Place Switches on Rail with arrows pointing away from
Power Head (Figure 14).
Place Close Limit Switch (Brown Wire) 15" from Rail Strap.
Insert (#8-32 X 1") Hex Head Screw into Switch hole and
finger-tighten until later.
Place Open Limit Switch (White Wire) 15" from Power Head.
Insert (#8-32 X 1") Hex Head Screw into Switch hole and
finger-tighten until later.
White
Wire
S
n Limit
As^^mbly
Ij
I 21
#8-32 X 1
Hex Head Screws
Wire Clips
5^
Emergency
Release Core
25
Close Limit
Switch Assembly
Emergency
Release Knob
Hardware (green bag)
Emergency
Release Tag
Close Limit
Switch
(Brown wire)
#8-32 X 1"
Hex Head^
Screws 0
Figure 14 Install Limit Switches on Assembled Rail
10
FcM' Help, call 1-S00-3S4SEiiE or visit %wi»i.ferilecornparif.ccirn