Manual

WARNING
TO REDUCE THE RiSK OF SEVERE iNJURY OR DEATH
1 READAND FOLLOW ALL INSTRUCTIONS.
2 Never let children operate or play with the Door Controls. Keep the Remote Control away from children.
3 Always keep the moving door in sight and away from people and objects until the door is completely closed.
NO ONE SHOULD CROSSTHE PATHOF THE MOVING DOOR.
4 NEVERGO UNDER A STOPPED,PARTIALLYOPEN DOOR.
5 Test Opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat)
at the center of the doorway on the floor. After adjusting either the Force or the Limit of travel, retest the Door
Opener. Failure to adjust the Opener properly may cause severe injury or death.
6 When possible use the Emergency Release only when the door is closed. Use caution when using this Release
with the door open. Weak or broken springs are capable of increasing the rate of door closure and increasing
the risk of severe injury or death.
7 KEEPGARAGE DOORS PROPERLYBALANCED. See Owner's Manual. An improperly balanced door increases the
risk of severe injury or death. Have a Genie Factory Authorized Dealer make repairs to cables, spring
assemblies, and other hardware.
8 SAVETHESEINSTRUCTIONS.
, WARNING
Usethe Wall Console included with Opener. Any other wall console can cause the Opener to operate unexpectedly and
the light to stop working.
TI%, yUBLEJHO,, y GUIDE
Source (Red LED)
ON
OFF
OFF
2 BLINKS, Pause
(Repeat)
2 BLINKS, Pause
(Repeat)
3 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
Sensor (Green LED)
_z_z
ON
OFF
ON
ON
OFF
,J
ON
ON
Possible Problem
Normal operation
• Power Head not powered
• Wiring from Power Head bad
• Wiring to Source missing or bad
• Beam not aligned
• Beam obstructed
• Sensor defective
• Wire to Sensor missing or bad
• Sensor defective
• Sensor receiving interference
• Source not sending pulses
• Source defective
Solution
None required
• Check breakers, fuses,plugs
• Checkwiring for obvious shorts
• Check wiring
• Check Source, Sensor alignment
• Check for obstruction
• Contact Customer Service
• Check wiring
• Contact Customer Service
• Determine source of interference
• Contact Customer Service
• Contact Customer Service
• Contact Customer Service