Manual

t+}F/0 6 _:/f%_tilP?}H6 T4_
_:_I_/_OT_
A To program one Button of a Remote Control (Figure 37):
• Locate Learn Button and Learn Indicator Light near
Terminal Block on Power Head (Figure :38).
. Press and release Learn Button. Red Learn Indicator Light
will blink 2 times per second.
Press Remote Control Button once within 30 seconds.
Red Learn Indicator Light will stay lit.
. Press Remote Control Button again. Red Learn Indicator
Light will go out, indicating that memory is stored.
B Program each additional Remote using step A above.
Yo D_se £II Bet;isotes fl_ols_s Rowe Head Is4_Jsi}oty
A Press and hold Learn Button on Power Head for 10 seconds or
until Learn Indicator Light goes out. Memory is erased:
. Program Remotes again as needed.
'R} F:lep/a e l:&Iemote Co_t_'o/Batte y
A Push in on Battery Cover Latch at base of Remote Control
(Figure 39):
. Use coin, pen, screwdriver or any similar device.
Cover snaps open.
. Replace old Battery with new _EVEREADV. A23,
12 Volt Battery.
B Snap Battery Cover closed.
WARNING
A moving garage door may cause serious injury or death.
• Keep people clear of opening while door is moving.
• Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
• Close the door and disconnect the Opener using the
Emergency ReleaseCord.
• Do not use the door Opener, Remote Controls, or
Wireless Keypad.
• Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
A Press Button on Remote Control. Garage door will move.
B Press Button again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
C Press Button again. Garage door will reverse.
NOTE
• Each Remote Control must be programmed
separately.
• The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam®System is malfunctioning.
• When programmin_ the Remote Controls, they
must be at least 24 from the Antenna Wire.
• If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped. If programming
has stopped, repeat the above steps.
• Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see"To EraseAll
Receiver Memory."
1 Button 2 Button
Remote Remote
® ©
Figure 37 Genie Remote Controls
3 Button
Remote
@
Learn Code Button
Figure 38 Learn Code Button and Indicator Light
Visor Clip
Push to open
Battery Cover
Model
Number
Figure 39 Remote Control Battery Replacement