Manual

ManualsBrandsGenie ManualsCarExcelerator

CAUTION

_tapleswhich are too tight may cut or pinch Wires. Cut or

)inched Wires can cause the Safe-T-Beam® System to stop

vorking. When installing the Insulated Staples, make sure

_oufasten them only as tightly as needed to hold the

Wire securely.

1 1

C Install Safe-T-Beam ® Wiring (Figure 28):

. Route Wire and Insulated Staples

(Figure 29 and Figure 30).

Securely fasten Wires with Insulated Staples as

you go. Staples should be snug only.

Wires between garage wall and Power Head should

be run on top of Rail and underneath Wire Clips.

Attach Wires to Safe-T-Beam ® Sensors.

Split and strip Wire ends to be connected as shown.

Loosen Terminal Screws.

Insert each Wire under flat plate and tighten Screw.

It does not matter which Wire, white or striped, goes

on which Terminal.

Attach Wires at Power Head.

Wires are connected toTerminals #2 and #3 on

Power Head Terminal Block. it does not matter which

Wire, white or striped, goes on which Terminal.

Check the following.

Ensure that no part of door or its hardware is in path

between Source or Sensor Lenses.

Ensure that tops of Lenses are between 5" - 6" above

floor. Brackets are flexible and can be adjusted slightly

if needed.

Insulated Staples

(approximately 30 parts)

Wi re

#6-11/4"

Pan Head Screws

Hardware (red bag)

approx.

1/2

Figure 28 Wire the Safe-T-Beam ® System

Wire Clips @

Insulated

Staples

NOTE

The Safe-T-Beam alignment check will be performed

following connection to electrical power.

Do Not plug in yet!

at Safe-T-Beam ® Leave slack for

adjustment

Terminal

attachments

at Power Head

Figure 29 Wiring Method A

Wire Clips (_