Manual

CAUTION
Doors made of masonite, lightweight wood, fiberglass, metal,
or other lightweight materials must be properly braced
before mounting door Opener.
_o s; c o_Idoos
A
B
Place Door Bracket on door center line, no lower than top
roller, and mark holes (Figure 19).
Attach Door Bracket:
For metal doors, use 3 (1/4"-2O x 3/4") Self-Drtling
Screws (provided).
. For wood doors, use 3 (1/4" x 2") Lag Screws or
3 (1/4" x 11/4") Lag Screws (not provided).
or@
--_ @
SECTIONAL DOORS
Line of door
ONE-PIECE DOORS
Optional Door Operator Bracket (not included)
Figure 19 Attach Door Bracket
NOTE
Before installing, check length of the included Lag Screws vs.
the thickness of your garage door. For doors thinner than 2,
use 11/4 Lag Screws. Check door condition and thickness.
See page 3.
Fo o_-_e-piec_;>doo s::
A Position Door Bracket on door's center line, as high as
possible or on top of door.
B Attach Door Bracket:
. Formetaldoors, use3(1/4"-2Ox3/4")Self-Drtling
Screws.
For wood doors, use 3 (1/4" x 2") Lag Screws.
SS]I'TtIC/4 I;IAIL 0 MEIsIi)EI
A While supporting the Power Head, place threaded end of Rail
Strap Bolt through Header Bracket hole (Figure 20).
B Attach (5/16"-18) Flange Nut to Rail Strap Bolt.
Finger-tighten until later.
Rail Strap Bolt
Rail (_)
Header Bracket
Figure 20 Attach Rail Strap to Header Bracket