SDS
5
US OSHA Table Z-1 Limits for Air Contaminants ( 29CFR 1910.1000)
Ingredient
CAS Number
Type
Value
Sulfuric Acid Absorbed in
Glass Fiber
7664-93-9
PEL
1 mg/m³
US ACGIH Threshold Limit Values
Ingredient
CAS Number
Type
Value
Form
Lead
7439-92-1
TWA
0.05 mg/m³
Sulfuric Acid
7664-93-9
TWA
0.2 mg/m³
Thoracic Fractions
US NIOSH: Pocket Guide to Chemical Hazards
Ingredient
CAS Number
Type
Value
Lead
7439-92-1
TWA
0.05 mg/m³
Sulfuric Acid
7664-93-9
TWA
1 mg/m³
International Exposure Limits (mg/m
3
)
*Chemical & Common Name
Quebec PEV
Ontario OEL
EU OEL
Lead and Lead Compounds (inorganic)
0.05
0.05
0.15 (a)
Electrolyte (H
2
SO
4
/H
2
O)
1
0.2
0.05 (b)
(a) As inhalable aerosol (b) Thoracic fraction
Biological limit values
ACGIH Biological Exposure Indices
Ingredient
Value
Determinant
Specimen
Sampling Time
Lead
300 µg/l
Lead
Blood
*
* - For Sampling details please see the source document.
Exposure Guidelines:
The OELs listed above are only applicable if the internal components of the battery cell are released. Follow standard
monitoring procedures.
Engineering Controls (Ventilation):
Store sealed lead acid batteries at ambient temperature. Never recharge batteries in an unventilated, enclosed space. Do
not subject product to open flame or fire. Avoid conditions that could cause arcing between terminals.
Respiratory Protection (NIOSH/MSHA approved):
NONE REQUIRED FOR NORMAL HANDLING OF THE FINISHED PRODUCT.
When concentrations of sulfuric acid mist are known to exceed PEL, use NIOSH or MSHA-approved respiratory protection.
Skin Protection:
NONE REQUIRED FOR NORMAL HANDLING OF THE FINISHED PRODUCT.
If battery case is damaged, use rubber or plastic acid-resistant gloves with elbow-length gauntlet, acid-resistant apron,
clothing and boots.
Eye Protection:
NONE REQUIRED FOR NORMAL HANDLING OF THE FINISHED PRODUCT.
If necessary to handle damage product where exposure to the organic electrolyte is a possibility, chemical splash goggles
and a face shield are recommended.
Other Protection:
Safety footwear meeting the requirements of ANSI Z 41.1 is recommended when it is necessary to handle the finished
product.