Replacement Part List

18
Adjust Carriage for (optional) Emergency Release System
The carriage on this opener can be adjusted to work with the Emergency Release Cable Lock System
(available at your local Genie® Retailer).
1. Operate door to mid position.
2. Pull emergency release cord and manually close door.
3. Make sure carriage latch is in the upright (engaged) position.
4. Remove (2) 5/16” machine screws and cap.
5. Pull spring assembly out and reverse direction.
6. Install cap and machine screws.
Emergency Release cable can now be assembled to the carriage assembly.
Rail, Chain, & Door
Arms not shown for
clarity
DOOR
CLEARING MEMORY OF REMOTES
NOTE: Clearing memory of remotes from the powerhead
will clear ALL programmed remotes, wireless keypads and
vehicle transmitters. The opener will no longer recognize
any signal from any remote device, including a missing
remote device. This does not include the Aladdin Connect
All remaining (or recovered) remotes, vehicles and
wireless keypads MUST be reprogrammed.
NOTE: The garage door opener will operate normally
using the wall console.
1. Press and hold the SET/PRGM button on the
opener for two seconds.
• The ROUND LED will turn BLUE.
• The ROUND LED will then ash PURPLE.
2. Press and hold the UP & DOWN buttons at
the same time until both LEDs turn o.
• Both opener LEDs will ash and turn o
indicating that all remotes have been
erased.
3. Press any remote button.
• The opener should NOT run.
To deprogram the same remote for other garage
door openers, repeat the steps above using one of
the other remaining remote buttons.
1. Enter Programming Mode
Solid Blue Flashing Purple
Flashing
Blue
2. Press and Hold + & - Buttons
3. Test Remote
Release when
LEDs turn o