Replacement Part List

10
Program Keypad before mounting.
Activate keypad by opening battery
compartment and pull protective
tab. Reinstall compartment door to
begin programming.
TAB
Program the keypad for the rst time* with a Personal
Identication Number (PIN). This PIN must be 3 to 8 digits.
1. Ensure number pad back lighting is o.
2. Press 3-5-7 in sequence.
3. Press PROGRAM key. LED will blink once per second.
4. Enter a PIN number (3-8 digits).
5. Press PROGRAM key. LED will blink twice and shut o.
STEP 1) PROGRAMMING A PIN NUMBER (Single Door)
1. Place garage door opener into PROGRAMMING MODE.
(SEE BELOW)
2. Ensure number pad back lighting is o.
3. Enter the PIN number on keypad.
4. Press the UP/DOWN key 3 to 4 times slowly until garage
door opener operates.
STEP 2) PROGRAMMING THE KEYPAD TO 1 OPENER
Single Door Operation:
1. Ensure number pad back lighting is o.
2. Enter PIN number.
3. Press the UP/DOWN key.
4. Opener will operate.
STEP 3) OPERATING THE KEYPAD WITH THE OPENER
NOTE: Keypad will remain active for 15 seconds after a
successful entry is made. During this 15 seconds ANY key will
operate the opener.
QuickViewSingleDoorsetup.
Pleaseseecompleteinstructionsthataccompanykeypad
1. Press and hold the program button on the powerhead
until the round LED turns blue, then release.
2. The round LED will go out and the long LED will begin
ashing purple.
3. Complete programming steps.
PUTTING OPENER INTO PROGRAMMING MODE:
NOTE: The openers LEARN LED will time out in 30 seconds.
Programming must be completed within 30 seconds.
Solid Blue
PRESS
&
RELEASE
Flashing Purple
Scan Code for a video of the complete
installation and programming.
Step1)ClearCar2Utodefaultsettings
•Press and hold buttons 1
and 3 for 20 seconds or
until all three LEDs begin
to ash.
•Release both buttons. The
Car2U system is now set to the Factory Default
settings
NOTE: Clearing the Car2U remote will remove all
previously programmed garage door openers.
Step2)ProgramCar2UtotheGenieOpener
•Place opener into programming mode. (See panel at left)
Press and hold the desired Car2U button until
door begins to move.
•Release button for one second.
•Press same button again, door should move.
NOTE: For additional instructions see the vehicle
owners manual, or www.learcar2u.com
Step1)ClearHomeLink
Clear HomeLink by pressing and holding down
the rst and third buttons
until the indicator on the
HomeLink blinks slow and
then fast for 20 seconds;
then release both buttons.
NOTE: Clearing the HomeLink will remove all previously
programmed garage door openers.
Step2)TrainHomeLinktotheGenieRemote
•Choose the button on the HomeLink that will be
used to open the door.
•Hold down the Genie remote button. While
holding, press and hold the chosen HomeLink
button.
•Hold down both buttons until the indicator on the
HomeLink blinks slow then fast. Once it blinks, release both
buttons.
Step3)ProgramHomeLinktotheGenieOpener
•Place opener into programming mode. (See panel
at left)
•Press programmed Homelink button 3 - 4 times or
until door operates.
NOTE: For additional instructions see the vehicle
owners manual, or www.homelink.com
QuickViewSingleDoorsetup.
Pleaseseecompleteinstructionsthataccompanyvehicle
Homelink® Programming
Car2U Programming
PROGRAMMING ACCESSORIES (abbreviated)