Use and Care Manual
Maintenance and Adjustments
6
If you have any questions, please do not hesitate to contact customer 
service at: 1-800-35-GENIE or visit www.geniecompany.com 
IMPORTANT SAFETY INSTRUCTIONS
REGULAR MAINTENANCE
Basic monthly maintenance tasks include:
•ContactReverse
•Safe-T-Beam®SystemCheck
•Doorbalance
•Lubricatedoorhardware
A. Contact Reverse Test
  See page 9.
B. Safe-T-Beam
®
 (STB) System Check
Check that both the RED and GREEN LEDs are ON steady. This 
indicates the system is working properly. If both LEDs are not ON 
steady, check the appropriate items below:
 •STBredLEDashes.
    – Check for obstruction.
    – Check alignment.
    – Verify wire routing from STBs to STB connection in powerhead
    – Check for signal interference from another Safe-T-Beam
®
 unit 
      (for multiple door installations).
 •NoSTBredorgreenLEDdisplayed.
    – Check wiring and wire connections.
If the system appears to be working properly, perform the check as 
follows:
  1. Start the door closing.
  2. Pass an object through the beam. The door should stop and   
    reverse to the fully open position.
C. Door Balance (Spring Tension)
Perform the check as follows:
 •Withthedoorclosed,pullmanualemergencyreleasehandle 
    DOWN and let go to release door carriage assembly from drive  
 system.
 •Raiseandlowerthedoormanually—itshouldmovefreelyand
 smoothly.
 •Raisedoormanuallyabout3'to4'feetandletgo.
– Door should remain stationary or move very slowly.
    – If door moves quickly, CONTACT A TRAINED DOOR SYSTEM   
      TECHNICIAN to have your door springs serviced.
 •Closethedoor.
          (continued next page)
 WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH, READ 
AND FOLLOW ALL INSTRUCTIONS.
1. NEVER let children operate or play with the door controls. 
2. Keep remote away from children.
3. ALWAYS keep the moving door in sight and away from people 
  and objects until door is completely closed. NO ONE SHOULD 
  CROSS THE PATH OF THE MOVING DOOR.
4. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 
5. Test opener monthly. The door MUST reverse on contact with a 
 1-1/2"highobject(ora2"x4"boardlaidat)atthecenterof 
 doorwayontheoor.Afteradjustingeithertheforceorlimitof 
  travel, retest door opener. Failure to adjust the opener properly 
  may cause severe injury or death.
6. When possible, use emergency release only when door is 
  closed. Use caution when using this release with the door open.  
  Weak or broken springs are capable of increasing the rate of 
  door closure and increasing the risk of severe injury or death. 
7. KEEP DOORS PROPERLY BALANCED. See your garage door 
  Owner’s Manual. An improperly balanced door increases the 
  risk of severe injury or death. Have a trained door system 
  technician make repairs to cables, spring assemblies, and 
  other hardware.
SAVE THESE INSTRUCTIONS
 WARNING
• Garagedoorhardware(springs,cables,brackets,pulleys,etc.) 
  are under extreme pressure and tension.
• DO NOT attempt to repair or adjust door springs or any hardware, 
 and DO NOT OPERATE garage door automatically or manually if   
  door is improperly balance or springs are broken.
• CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.
 WARNING
Use of any other wall control can cause unexpected operation of 
the door and loss of lighting feature. Locate wall console within 
sight of door and far enough from door to prevent contacting it 
while operating the console. Control must be at least 5 feet above 
oortopreventsmallchildrenfromoperatingit.
3' - 4'
Sectional Door 
3' - 4'
One-Piece Door 
16










