Instructions / Assembly

PN# 3642036534, 02/26/2010 REV. 1
16
3.Securely fasten wires.
• Securely fasten wires to ceiling and
wall using insulated staples provided.
– Use insulated staples.
– Staples should be snug only.
• If rear cover is attached to power head,
remove it.
• On power head:
– Route wall console wires through wire guide on
power head.
– Split and strip ends of wire (Fig. 3-2 on
previous page).
– Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips.) The white
wire into #1 terminal hole and striped wire into
the #2 terminal hole.
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
• Do NOT install rear cover yet.
4. Mounting.
• Fasten wall console to wall with 2 screws
(provided) (Fig. 3-4).
• Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
– Stick label on wall near wall console.
Insulated
Staple
+–
PB
Infrared Sensor
123456
FIG. 3-3 Insert wires .
(Power Head With Rear Cover Removed)
12 34
Terminal
Holes
Locking
Clips
56
wire guide
FIG. 3-4 Mounting Wall Console.
Child can be pinned under automatic garage
door.
Death or serious injury can result.
•
Never let child walk or run under moving door.
.
•
Neve
r let child use door opener controls.
•
Always
keep movin
g
door in sight.
•
If person is pinned, push control
button or use
emergency release.
•
Test door opener monthly:
Refer to your owner s manual
P
lace 1
/ -inch object (or 2x4 laid flat) on f
oor
If door fails o reverse on contact adj
ust opener
If op
ener sti l fails o revers
e d
oor repair
or replace opener
Do not
remove or pa
nt ov
er this label
Mou nt wa l co n rol
ou
t o f ch i d s re ach
(at le
ast
5 f ee
t
abo v
e f loor )
Plac
e next t o wal
l
on
trol
©1999
FIG. 3-5 Mounting Entrapment warning label.
3
2
1
Independent Light Control
– Controls door opener lights from inside garage
– Energy-Saver shut-off turns OFF lights 3 minutes after
door activation
Vacation Locking Switch
– LOCK disables controls after
door is completely closed
– UNLOCK allows controls to
work normally
Door Control "Open/Close" Button
– Open and closes door from
inside garage