User's Manual

Getting Ready
All Geni products are thoroughly tested at the factory and shipped in perfect
condition. If damage has occurred during shipping or if components are
missing, please contact your Geni dealer immediately.
Your package should include:
TM
(1) One Mojo Spin Master series lighting effect with bracket.
(2) One IEC electric mains power cord with plug.
(3) One product user manual.
The lamp may or may not be included, depending on your Geni dealer. In most
cases, the lamp is not included.
Install the Lamp
TM
Mojo Spin Master series effects use either the GX5.3 24V/250W lamp by
Osram or the ELC lamp of identical specifications by Philips. Use only the
appropriate lamp for your unit. Note that product versions that use other lamps
may be offered in the future. Check your product specification label for
information.
Lamp Installation
(1) Loosen the two screws on the top of the lamp cover. Open the case.
(2) Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 1.)
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off
the glass with a clean, lint-free towel and rubbing alcohol.)
(3) Hold the lamp socket with one hand. Insert the lamp pins into the holes in
the lamp socket.
(4) Make sure that the lever is up. Slide the lamp into the lamp base.
(5) Put on the lamp cover and fasten the screws snugly.
2
9
A
B
C
D
E
Lamp Items
A - Lever
B - "ELC" Lamp
C - Lamp Base
D - Lamp Socket
E - Lamp Pins
Figure 1
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a
problem occurs, carry out the steps below in sequence until a solution is found.
Once the unit operates properly, do not carry out following steps. If the effect
does not operate properly, refer servicing to a technician.
No Light, No Movement - All Products
Response: Suspect three potential problem areas: the power supply, the lamp,
the fuse.
1. Power supply. Check that the unit is plugged into an appropriate power
supply.
2. The lamp. Replace the old lamp with a new one of appropriate
specifications. See directions above for replacing lamps.
3. The fuse. Replace the fuse. See directions above for replacing the fuse.
No Response to DMX
Response: Suspect the DMX dip switch setting, DMX cable or connectors, a
controller malfunction, a light effect DMX card malfunction.
1. Check the DMX dip switch setting. Make sure the DMX dip switch address
setting is correct.
2. Check the DMX cable: Unplug the unit; change the DMX cable; resupply
electrical power. Try your DMX control again.
3. Determine whether the controller or light effect is at fault. Does the controller
operate other DMX products properly? If not, take the controller in for repair.
If so, take the DMX cable and the light effect to a qualified technician.
No Response to Audio
1. Check the function setting of the first unit. Make sure that function dip switch
#1 is on. (Function dip switch #1 on = audio control.)
2. Turn up the music volume.