User's Manual

IMPORTANT NOTICE!
FCC RF Exposure Compliance requirements for Occupational Use:
• This device must be restricted to work related operations in an occupational / controlled RF exposure
environment.
• Transmitting duty factor may not exceed 50%.
• All qualified users must have the knowledge to control their own, passengers and bystanders ’RF
exposure to comply with the General Population / Controlled MPE limit and requirements.
• The antenna used for this transmitter must be installed to provide a separation distance of at least 32cm
from all persons and must not exceed an antenna gain of 0 dDd.
IMPORTANT NOTICE!
This radio can only be programmed to frequency by qualified, approved technicians using a separate PC
software and cable package. Only authorized technicians can contact Tekk to purchase this programming
software product.
CH.1 PRODUCT INTRODUCTION
SD-5200, This RF Data Radio is designed to operate in the frequency range is 450MHz~ 470MHz. Inside of SD-5200 is
installed microprocessor and SD-5200 is operated by PLL type. RF power is 2watt and 5watt. Bandwidth is 12.5khz or
25khz