User's Manual

ROGERS LABS, INC. Genex Electronics
4405 W. 259th Terrace MODEL: FRS 300
Louisburg, KS 66053 Test #: 010419
Phone/Fax: [phone] Test to: FCC Parts 2 and 95 Page 4 of 2
FRS300Manual.doc 05/18/2001
_ To activate or disable the Roger tone
- Press the Function [F] button until [rb on or oF] and the Roger [ ] icon blink on the LCD.
- Press the up[ ↑ ] button or down [ ↓ ] button.
- Press the PTT button or Function [F] button to confirm.
9) Setting the Ringer
- This feature provides 3 user selectable call ringer signal and vibration.
To set your favorite call ringer signal.
- Press the Function [F] button until the [ CA 1 or up to 3 ] appears on the LCD.
- Press the up[ ↑ ] button or down [ ↓ ] button to select the call melody type.
- Press the PTT button to confirm.
- To activate the call , click the "PTT" button twice quickly.
10) Setting the Vibration Modes
° To set for Vibration
- Press the Function [F] button until the [ Ub on or oF ] and Vibrator[ ] icon blink on the LCD
- Press the up [ ↑ ] button or down [ ↓ ] button.
- Press the PTT button or Function [F] button to confirm.
11) Transmitting
- Press and hold the PTT button (The "TX" LED will light with red color)
- Speak slowly and clearly
- To stop the transmission, release the PTT button
- If there are no more receiving signal for 5 seconds, the unit will go into power save mode and then the
"TX" LED will blink with green color.
12) Receiving
The coding feature reduces the possibility of interference and provides enhanced communication.
You can only listen to a call that has correct matching code.
Important ;
Before transmitting or receiving to the other parties ;
- Correct channel is selected ( 1 to 15 ) and
Correct code is set ( 00 to 38 )
13) Channel Scanning
This feature allows you to monitor all activated channels while scanning.
% To activate the Scan
- Press the Scan[S] button
- Radio will begin scanning.
- When in scan mode, the display will show each scanning channel.
- After an activated channel is scanned and received signal and then if there is no more signal, the scan
will resume automatically.
% To disable the Scan
- Press the Scan[S] button, the unit will stop the scanning.
- SCAN icon indicator will disappear from the LCD
- The unit will return to home channel.
14) Call
- Press the Call[C] button.(The "TX" LED will light with red color.)
15) Monitoring the channel
It is used for listening the week signal or to hear all activities on the channel by manually overriding
channel sub tone code setting.
% To activate the Monitor feature
- Press and hold the Monitor[M] button for over two seconds.
- When you hear the sound, release the Monitor[M] button.
(The monitor[ ] icon will appear on the LCD.)