User's Manual

simply press the scan button for a short time while stopped on the channel
to be detected. This will remove that channel from the scan list until the
channel is changed or the radio’s power is reset. When power is restored
or the scan list channel position is again selected, the original dealer
programmed scan list will be activated.
- Priority Scan On : A single channel is programmed as the “ Priority” channel.
The radio will constantly monitor this channel with flashing LED while scanning and
when the radio has stopped on an active channel. If a call is detected on the “priority”
channel, the radio will automatically move to, and remain on the “ Priority” channel as
long as the priority conversation takes places. “priority” channel activity takes
precedence over all other conversations.
- Priority Scan Off : To be out of “Priority scan” Just change Channel.
Radio will stop for a programmed delay time and start scanning on priority scan option
activity channel.
- Look back (Receiving correct call in Priority scan mode)
Any channel, when not in the scan mode can be programmed to “look back” at the
priority channel. This feature is ideal for those who do not need scan as defined above,
but want to make sure that they never miss a call on the “priority” channel if another
channel has been selected, the radio will periodically “look back” at the Priority
channel. If activity is detected on the “priority” channel, the radio will move to that
channel for as long as it remains active.
- Priority Scan TX : If a coming signal is not correct call, allow transmission on the normal
channel. If a coming signal is a correct call, allow transmission on the correct call channel.
After finish transmission, resume scan after scan delay time.
- Muti Scan : if press Scan key while Priority scan mode is On, Priority Channel
scan and Normal scan will take place at the same time under this condition,
scan sequence will be as below.
N-Ch(1) ===Î P-Ch ==Î N-Ch(2)===Î P-Ch ===Î N-Ch(3)……
4. TX operation
1) PTT TX