User's Manual

- Muti Scan : if press Scan key while Priority scan mode is On, Priority Channel
scan and Normal scan will take place at the same time under this condition,
scan sequence will be as below.
N-Ch(1) ===
Î
P-Ch ==
Î
N-Ch(2)===
Î
P-Ch ===
Î
N-Ch(3)
……
4. TX operation
1) PTT TX
Allows transmission with pressing PTT.
2) To enable VOX function, first of all VOX function and its level must be set
through PC programmer and then turn Radio `
on while pressing PTT. At a moment, radio makes beep sound.
3) TOT (TX Time-out-Timer)
This function will be disable TX.
When TX inhibit is used in conjunction with the time our timer, Radio will not
be able to transmit for the programmed period of time after a time out
occurs.
4) TOT Penalty option.
When a TOT occurs, TX will be inhibited for the penalty time.
5) BCL(Busy Channel Lock) option.
This function will inhibit TX on the operating channel while a signal is being
received.
6) BCLO(Busy Channel Lock out) option.
Even if a call is being received, this function allows TX. It also can allow TX
with correct tone.
7) TX Delay Option
This function is used to remove squelch tail caused by using CTCSS tone.
5. Power Save
1) TX Power save on
The time of TX power save on can be set by programmer, while radio is in
Power save on condition, TX/RX is not allowed. To be out of this mode, just
press any key.
2) Power Save Off.
The time of
“
power save off
”
can be set by programmer.