User's Manual

scan delay time has expired. Scanning will continue until the channel is changed
or press scan button again.
- Scan channel Delete : To temporarily delete a channel from the scan list,
simply press the scan button for a short time while stopped on the channel
to be detected. This will remove that channel from the scan list until the
channel is changed or the radio
’
s power is reset. When power is restored
or the scan list channel position is again selected, the original dealer
programmed scan list will be activated.
- Priority Scan On : A single channel is programmed as the
“
Priority
”
channel.
The radio will constantly monitor this channel with flashing LED while
scanning and when the radio has stopped on an active channel. If a call is
detected on the “priority” channel, the radio will automatically move to, and
remain on the
“
Priority
”
channel as long as the priority conversation takes
places.
“
priority
”
channel activity takes precedence over all other
conversations.
- Priority Scan Off : To be out of
“
Priority scan
”
Just change Channel.
Radio will stop for a programmed delay time and start scanning on priority
scan option activity channel.
- Look back (Receiving correct call in Priority scan mode)
Any channel, when not in the scan mode can be programmed to
“
look back
”
at
the priority channel. This feature is ideal for those who do not need scan as
defined above, but want to make sure that they never miss a call on the
“
priority
”
channel if another channel has been selected, the radio will
periodically
“
look back
”
at the Priority channel. If activity is detected on the
“priority” channel, the radio will move to that channel for as long as it
remains active.
- Priority Scan TX : If a coming signal is not correct call, allow transmission on
the normal channel. If a coming signal is a correct call, allow transmission on
the correct call channel. After finish transmission, resume scan after scan delay
time.