User's Manual

Allows transmission with pressing PTT.
2) To enable VOX function, first of all VOX function and its level must be set through PC
programmer and then turn Radio `
on while pressing PTT. At a moment, radio makes beep sound.
3) TOT (TX Time-out-Timer)
This function will be disable TX.
When TX inhibit is used in conjunction with the time our timer, Radio will not be able to
transmit for the programmed period of time after a time out occurs.
4) TOT Penalty option.
When a TOT occurs, TX will be inhibited for the penalty time.
5) BCL(Busy Channel Lock) option.
This function will inhibit TX on the operating channel while a signal is being received.
6) BCLO(Busy Channel Lock out) option.
Even if a call is being received, this function allows TX. It also can allow TX with
correct tone.
7) TX Delay Option
This function is used to remove squelch tail caused by using CTCSS tone.
5. Power Save
1) TX Power save on
The time of TX power save on can be set by programmer, while radio is in Power
save on condition, TX/RX is not allowed. To be out of this mode, just press any key.
2) Power Save Off.
The time of “power save off” can be set by programmer.
In this condition, allows only RX.
3) Power save delay.
Power save mode can be cancelled whenever occurs key/TX event.
This function forces radio not to go back to Power save mode during Power save delay
time that is programmable.
4)Power Save Sequence
Power Save Delay ==Î Power Save On ===Î
Power Save Off ====Î Power save off ….