Programming Manual

1. Read : Click READ button, it can be read the data from SET.
Term:
1> SET is turn means that press Monitor key and Scan key simultaneously. And then LED lights of
SET will be turned to orange color.
2> Programmer cable connect between PC and Set.
3> Press READ button.
4> Error message will show as it below either cable does not connect or does not set PC link mode.
5> When job is done, it shows as it below and disappear..
2. Write : You can write the data when you click the button.
Condition:
1> SET is turn means that press Monitor key and Scan key simultaneously. And then LED lights of
SET will be turned to orange color.
2> Programmer cable connect between PC and Set.
3> Press WRITE button.
4> It will ask you a question as it below because exisitin data will be erase when you write the data
set.