Programming Manual

4) Scan : Automatic scan receiving channel.
• Scan Enable : Scan Enable/Disable
• Scan Speed : Delay time for No busy channel.
Setting 10msec between 50msec ~ 500msec.
(Default : 100 msec)
• Scan Delay : Delay time of Busy channel. You can set 1sec delay between 1sec to 30sec. (Default :
5sec)
• Priority Scan Enable : Priority Scan Enable/Disable
• Prio. Scan Ch. No. : Priority Channel
• Look Back time : Interval time for checking Priority channel when Non Priority Channel is busy. (0.5sec
~ 10sec : Default 4sec)
5) Power Save : If there is no signal comes in stand by mode, it goes power saving mode which set PC
program.
• Power Save Enable : Power Save Enable/Disable
• Save On time : Power Save On Time
You can set 0.1sec delay between 0.2sec~2sec.
(Default : 0.2sec)
• Save Off Time : Power Save Off Time
You can set 0.1sec delay between 0.2sec~2sec.
(Default : 0.2sec)
• Save Delay time : Need time from normal mode to power save mode.
You can set 0.5sec delay between 0.5sec~10sec.
(Default : 5sec)
6) TOT ( Time Out Timer)