User's Manual

The time of “power save off” can be set by programmer.
In this condition, allows only RX.
3) Power save delay.
Power save mode can be cancelled whenever occurs key/TX event.
This function forces radio not to go back to Power save mode during Power save delay
time that is programmable.
4)Power Save Sequence
Power Save Delay ==Î Power Save On ===Î
Power Save Off ====Î Power save off ….
6. Low Battery Detection
1) RX Low battery
If Low battery condition is detected, Radio flash LED with beep sound. In this condition
RX/TX is inhibited but one time of TX is allowed.
2) TX low battery
If Low battery condition is detected while TX is active, Radio allows TX
but it will be inhibited right after end of TX. There is still one-time TX chance in the low
battery condition.
7. Scramble Function
Four different kind of scramble can be selected to each channel.
If the same scramble is set on the same channel for each other, Normal conversation will
be possible.
8.PC Link
Turn radio on while pressing monitor and scan button at the same time.
Radio flash LEC in orange
To be out of PC link condition, Turn radio Off and the On.
9.Clone function
1) This function gives two radios same data with clone cable.
2) To set master radio which transmit data, Turn radio on while pressing PTT
and Monitor button at the same time, LED will be On in Red
3) To set slave radio which receive data from Master radio.
Turn radio on while pressing PTT and Scan button at the same time.