User's Manual

GMRS-1904BLT Basic Operation 03-03-28
8 of 9
Alert setting is available in Weather Function only.
? To set the Weather alert receiving Function
- Press the Function[F] button until the [ AL on or oF ] blinks.
- Press the up[?] button or down [?] button to set the alert function.
- While the alert is ON, weather[WX] icon will blink both in GMRS and weather Function.
- Weather[WX] icon will stop the blinking on the LCD when the alert is OFF.
- While the unit is in GMRS Function, if the alert signal is received, the unit will set to Weather
Radio Function automatically and warning beep tone will generate.
- While the unit is in Weather Function, if the alert signal is received, the unit will generate the
warning beep tone.
FCC Information
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS :
(1) THIS DEVICE MAU NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED OPERATION.
Safety Information For GMRS UNIT
“Important: FCC RF Exposure Requirements:
- Operation must not exceed a maximum transmitting duty factor of 50% for satisfying RF exposure compliance.
- For body-worn operation, this radio has been tested and meets the FCC RF exposure guidelines when used
with GENEX accessories supplied or designated for this product. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines. Use only the supplied antenna. Unauthorized antennas,
modifications, or attachments could damage the transmitter and may violate FCC regulations. “
Normal Position: Hold the transmitter approximately 1” from your face and speak in a normal voice,
with the antenna pointed up and away.
GMRS Licensing requirements: The Code of Federal Regulations requires the owner/operator
of this equipment to hold a FCC license when operating in the GMRS mode. Operation on the GMRS
frequencies is subject to additional rules as specified in 47 CFR Part 95.