User's Manual

- 13 / 16 -
This material may not in whole or part be copied, stored electronically or communicated
to third parties without GENEX Telecom’ s prior agreement in writing.
3.7.2 Paring the headset from Mobile phone having bluetooth to Audiogate
1) While the headset is paired with mobile phone with bluetooth, press Volume Up/Down button (Power
button) for 3 seconds and it sounds “Ding Dong” and then “Ding Ding Ding”.
2) And then press press Volume Up/Down button (Power button) until it sounds “Ding Dong Dang”.
5) “Ding Dong Dang” means the headset is connected to the audiogate that were packed with headset when
you purchased this products .
3.8 Low Battery Indicator
1) If the headset is short of battery, it sounds a “ding-dong-ding-dong” at proper intervals.
2) Red LED is blinking at 3 seconds intervals .
3.9 Audio Signal (Headset Speaker)
1) Ding Dong Dang : When Idle (Before connection to audiogate))
2) Ding Dong : when connection is done
when Headset turn off
3) Ding : when press the connection button of Headset,
when press volume Up/Down button
3) Beep : when delete Pairing information and enter idle mode( see section 3.7.1)
4) Ding Ding Ding : Default Dongle (3.7.2).
5) Ding Dong Ding Dong : Low Battery
3.10 Volume Control
The volume of the Headset is controlled by handling the Volume control button.
The changed Volume is stored at memory.