Use and Care Manual

English
12" Dual-Bevel Sliding Compound Miter Saw
Operator’s Manual GMSDB1215LF
18
LOCKING AND UNLOCKING THE SLIDING RAIL (FIG 25)

        


CUTTING WITH A SLIDING MITER SAW
(FIG 26)
         

        







          






APPLICATION
TYPICAL COMPOUND MITER SAW OPERATIONS
WARNING: Always be sure the miter saw is disconnected from the power
source before making any adjustments or during set-up prior to cutting. Failure to
disconnect or unplug the machine may cause accidental starting, resulting in serious
personal injury.
WARNING: Be sure the miter saw is securely bolted down or clamped to a
workbench or appropriate work surface before performing any cutting operations.
Failure to do so may result in loss of machine control and/or result in personal injury.
WARNING: If securely holding the workpiece causes your hand to be in the
machine’s “Hazard Zone”, clamp the workpiece in place and move your hand(s) to a
safe position before making the cut.




 
 



 

  

1
FIG 25
2
FIG 26
a
b
c
d