Use and Care Manual

English
12" Dual-Bevel Sliding Compound Miter Saw
Operator’s Manual GMSDB1215LF
16
To Unlock the Cutting Head




STARTING AND STOPPING THE MITER
SAW (FIG 19)
NOTE: 


To Start the Miter Saw


To Stop the Miter Saw,
WARNING: After completing a cut, release the trigger switch to activate the
electric blade brake. Keep the cutting head down until the blade comes to a complete
stop before raising the cutting head to the upward or starting position. A rotating saw
blade can be dangerous.
WARNING: The torque resulting from electric blade brake activation may
loosen the arbor bolt. Occasionally check the arbor bolt and tighten if necessary.
LASER GUIDE (FIG 19)
WARNING: Laser light – Do NOT stare into the beam, aperture, or into a
reflection from a mirror-like surface.
WARNING: Avoid exposure – laser light is emitted from the laser assembly.
Use of controls or adjustments, or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
WARNING: DO NOT disassemble the laser module.
WARNING: USE of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.


LED Work Light (FIG 19)


TABLE HAZARD AREA (FIG 20)


         


 WARNING: Keep your hands outside
the “Hazard Zone” and out of the path of the
saw blade. Use the supplied work clamp or other
clamping means to secure the workpiece in place
before making a cut with the miter saw.
3
5
FIG 19
2
1
4
FIG 20