Use and Care Manual

11
English
DETENT LEVER (FIG 3)

          

   


DUST BAG & PORT







TABLE EXTENSIONS (FIG 4)
        
   
          
        


WORK CLAMP ASSEMBLY (FIG 5)
WARNING: In some operations, the work clamp assembly may interfere with the
operation of the blade guard assembly. Always make sure there is no interference with the
blade guard prior to beginning any cutting operation to reduce the risk of serious personal
injury.
      










NOTE: 

CHANGING THE SAW BLADE (FIG 6, 7, 8, 9)
WARNING: Be sure that the tool is switched off and unplugged from the power
source before performing any work on the tool.
WARNING: Use only 12 inch diameter saw blades and are rated for speeds
equal to or greater then the nameplate rated RPM of this miter saw.
WARNING: Use only blades designed forcross-cutting operations.
WARNING: Do not use thin kerf blades with deep gullets which may deflect
and contact the blade guards or produce poor quality cuts in the workpiece.
FIG 3
1
FIG 4
2
3
1
FIG 5
1
2 3