Use and Care Manual
11
English
NOTE:Some accessories, such as a saw blade, may be mounted either
straight on the tool, or at an angle to enhance usability. Always make sure the
4 pins are engaged as in step 2 above.
To install the Sanding pad and Sandpaper
NOTE: For maximum sandpaper life, rotate the pad or sandpaper 120
degrees when tip of sandpaper becomes worn.
WARNING: DO NOT tighten the cap screw unless the accessory is
properlyseatedontheshaftange.
To remove accessories from the tool,
OPERATION
WARNING:
To reduce the risk of serious personal injuries, read and
follow all important safety warning and instructions before using this tool.
WARNING: Always disconnect battery pack from tool or place the
switch in the locked or off position before any assembly, adjustments or
changing accessories
.
Switch Action (FIG 4)
To start the oscillating tool
To stop the oscillating tool
Overload Protection
FIG 4