SDS

Page 5/10
Safety Data Sheet
29 CFR 1910.1200
Printing date 02/15/2019 Reviewed on 01/23/2019Version number 1
Trade name:
Lithium battery ISR18650 3.7V 2000mAh
(Contd. of page 4)
48.1.25
7429-90-5 Aluminum (8.0%)
PEL (USA) Long-term value: 15*; 5** mg/m³
*Total dust; ** Respirable fraction
REL (USA) Long-term value: 10* 5** mg/m³
as Al*Total dust**Respirable/pyro powd./welding f.
TLV (USA) Long-term value: 1* mg/m³
as Al; *as respirable fraction
·
Regulatory information
PEL (USA): Guide to Occupational Exposure Values (OSHA PELs)
REL (USA): Guide to Occupational Exposure Values (NIOSH RELs)
TLV (USA): Guide to Occupational Exposure Values (ACGIH)
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Based on the composition shown in Section 3, the following measures are suggested for occupational safety
measure
·
Appropriate engineering controls:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes and skin.
See Section 7 for information about design of technical facilities.
·
Personal protective equipment
·
Breathing equipment:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use respiratory protective device that is independent of circulating air.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material:
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
Eye protection:
Tightly sealed goggles
9 Physical and chemical properties
·
General Information
·
Appearance:
Form:
Solid
(Contd. on page 6)
USA