Warranty

Limited Two Year Warranty
Genesis Power Tools are warranted free from defects in material and workmanship for (2) two years after
date of the original purchase. This Limited Warranty does not cover normal wear and tear or damage
from neglect or accident. The original purchaser is covered by this warranty and it is not transferable.
Prior to returning a tool to the store location of purchase, please call our Toll-Free Help Line for possible
solutions: 888-552-8665
Genesis NiCad and Lithium-Ion Batteries are warranted for (1) one year.
Accessories are not covered by the Two Year Warranty.
Genesis Power Tools, Batteries and Accessories are not warranted if used for industrial or commercial
purposes.
How To Get Service
Contact our toll-free consumer service line at 1-888-552-8665 to make a warranty claim or send the tool
prepaid to Richpower Industries Inc, 736 Hampton Road, Williamston, SC 29697, Attn. Warranty Repair
for warranty service. You must also include a dated proof of purchase (for example, a receipt of
purchase).
Additional Limitations
This warranty is only valid for products purchased and used in the United States, its territories or Canada.
Any implied warranty granted under state law, including warranties of merchantability or fitness for a
particular purpose, are limited to two years from the date of the original purchase. Richpower Industries,
Inc. is not responsible for direct, indirect, incidental or consequential damages including, but not limited
to, liability for loss of income arising from the purchase or use of the product. Some states and provinces
do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or
limitation of incidental damages, so the above limitations and exclusions may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights which vary from state to state
or province to province. Richpower Industries, Inc. declines any responsibility in regards to civil liability
arising from abusive use or not in conformity with proper use and maintenance of the tools as described
in the operator’s manual.
