User's Manual

9
English
ASSEMBLY
WARNING: Always be sure that the tool is switched off and unplugged
from the power source before adjusting, adding accessories, or checking a
function on the tool .
Installing or replacing Sanding Disc and
Guard (FIG 3)
One6"sandingdisc(3)andthedisc guard (1) are pre-
installedatthefactory.
To replace the sanding disc
1.Unplugthesanderfromthepowersource.
2. Using a Phillips screwdriver, loosen and remove two
screws(2)onthediscguard.
3.Removethediscguard.
4.Peelofftheoldsandingdisc.
5. Remove the backing from a new sanding disc. Align
perimeterofdiscwithsandingplateandrmlypressthe
discintoposition.
6.Reinstall the disc guard as shownon FIG 3.Thedisc
guardcanbeadjustedupand downtocoversanding
discformoreprotection.
Installing or Replacing Sanding Belt
(FIG 4, 5, 6)
Asandingbeltispre-installedandalignedatthefactory.
To replace the sanding belt
NOTE:Use 4"x36" (100mm x 914mm) sanding
belt. On the smooth side of the sanding belt,
there is a directional arrow. The sanding belt
must run in the direction of the arrow.
1.Unplugthesanderfromthepowersource.
2.PulltheBeltTensionLever(1)atdirectionshownonFIG
4toreleasebelttension.
3.Loosenandremovethescrew(3)oneachsideofbelt
bed(8).Removetheupperbeltguard(5).
4.Loosenandremovetwoscrews(4)oneachsideofbelt
bed(8).Removethelowerbeltguard(7).
5.Removetherubberbump(6).
6.Removetheoldsandingbelt(10)fromdriver(9)andidler
rollers(10).SeeFIG6.
7.Placeanewsandingbeltoverthedriverroller(9)and
idler roller (10) with the direction arrows running
counter-clockwise.Besurethesandingbeltiscentered
onbothrollers.
8.Putrubberbump,lowerbeltguardandupperbeltguard
backon.Tightenscrews(3,4)onbothsidesofthebelt
bed(8)tokeepguards(5,7)inplace.
9.Pushthebelttensionlever(1)backintolockingposition
toapplybelttension.
FIG 3
1
2
3
FIG 4
1
2
FIG 5
3
4
8
5
7
6
FIG 6
9
10
11